Owners Manual

Figure 101. Removing right control panel
NOTE: The images shown here are for representation only and the actual configuration of your system may vary.
Next steps
Install the right control panel.
Installing the right control panel
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Route the control panel cable and VGA cable through the side wall of the system.
2. Align the control panel with the control panel slot on the system and attach the control panel to the system.
3. Connect the VGA cable to the system board.
4. Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
5. Using Phillips #1 screwdriver, install the screw that secures the control panel and cable tube to the system.
Installing and removing system components
129