Owners Manual

Figure 97. Installing the system board
Next steps
1. Install the following:
a. Trusted Platform Module
NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-
in module will be provided for all system board replacements where a TPM plug-in module was installed.
b. Mid drive tray (if applicable)
c. Rear drive cage (if applicable)
d. Integrated storage controller card
e. All expansion card risers
f. Processor and heat sink module
g. Processor blanks (if applicable)
h. Memory modules and memory module blanks
i. Network daughter card
j. Cooling fan assembly
k. Air shroud
l. Power supply unit(s)
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Follow the procedures in After working inside your system.
4. Ensure that you:
a. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the Manually update the Service Tag section.
b. Update the BIOS and iDRAC versions.
c. Re-enable the Trusted Platform Module (TPM). For more information, see the Upgrading the Trusted Platform Module
(TPM) section.
5. Import your new or existing iDRAC Enterprise license.
For more information, see Integrated Dell Remote Access Controller User's Guide, at Dell.com/idracmanuals.
124
Installing and removing system components