Owners Manual

Steps
1. Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
2. Lift the integrated storage controller cable away from the integrated storage controller.
Figure 72. Removing the integrated storage controller cable
3. Lift one end of the card and angle it to disengage the card from the integrated storage controller card holder on the system
board.
4. Lift the card out of the system.
5. Hold the interposer board by its edges, and pull the board until the connector on the board disengages from the connector
on the system board.
Figure 73. Removing the integrated storage controller card
Next steps
Install the integrated storage controller card.
Installing and removing system components
107