Owners Manual

Installing the network daughter card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Figure 71. Installing the network daughter card
Next steps
1. Install the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
2. Follow the procedures in After working inside your system.
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage
controller card provides the storage subsystem for internal drives of your system. The controller supports SAS and SATA drives
and also enables you to set up the drives in RAID configurations as supported by the version of the storage controller.
This section contains information about the removal and installation of the integrated storage controller card.
Removing the integrated storage controller card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the air shroud.
4. Remove the expansion card riser 1.
106
Installing and removing system components