Owners Manual

Next steps
1. Install the air shroud.
2. If removed, install the expansion cards into the riser.
3. If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
4. Follow the procedures in After working inside your system.
5. Install any device drivers required for the card as described in the documentation for the card.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the flexibility of selecting different
network connectivity options.
This section contains information about the removal and installation of the network daughter card.
Removing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system
board.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Figure 70. Removing network daughter card
Next steps
Install the network daughter card.
Installing and removing system components
105