Users Guide

Table 6. Tasks run on Dell EMC devices by using the DSMPS monitoring features
DSMPS tasks run on
the SCOM console
DSMPS monitoring features
Server and Rack Workstation
monitoring feature using OMSA
Server and Rack
Workstation monitoring
feature using iSM-WMI
DRAC monitoring feature
iDRAC Hard Reset No Yes No
Clear ESM Logs Yes No No
Power management-related tasks
Check Power Status Yes No No
Force Power Off Yes No No
Power Cycle Yes No No
Power off Gracefully Yes No No
Power On Yes No No
Power Reset Yes No No
Turn LED Identification
On
Yes No No
Turn LED Identification
Off
Yes No No
To run the monitoring feature-based tasks on a SCOM console, see Run DSMPS monitoring feature-based tasks on SCOM on
page 25.
Check connection to the nodes
By running the Check Node Interfaces task, you can check if the selected Dell EMC device or DRAC/IDRAC and its
corresponding interfaces are reachable. After the task is successfully run, a summary of the reachability to the server and
interface is displayed.
View warranty information of PowerEdge servers
By running the Get Warranty Information task, you can view the warranty status of the Dell EMC device.
Start OMSA on monolithic servers using the SCOM console
By running the Launch Dell OpenManage Server Administrator task, you can start the Dell OMSA application.
NOTE:
The Dell EMC Server Management Pack Suite (DSMPS) tasks open the remote console when using Internet
Explorer.
Start iDRAC using the SCOM console
By running the Launch Dell EMC Remote Access Console task, you can start the Dell iDRAC application.
Start Remote Desktop on monolithic servers using the SCOM
console
By running the Launch Dell EMC Remote Desktop task, you can start a Remote Desktop on Dell EMC monolithic servers.
26
Supported tasks on the SCOM console for DSMPS monitoring features