Install Guide
Table Of Contents
- Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager (SCOM) Installation Guide
- Overview
- OMIMSSC components
- System requirements for OMIMSSC
- Installing, configuring, and managing OMIMSSC
- Managing OMIMSSC and its components
- Viewing OMIMSSC details
- Dell EMC OMIMSSC user management
- Viewing or refreshing enrolled consoles
- Modifying Operations Manager account
- Modifying credentials used for the enrolled consoles in Dell EMC OMIMSSC Admin portal
- De-enrolling the Operations Manager console
- Removing Dell EMC OMIMSSC appliance Virtual Machine (VM)
- Viewing jobs
- Installing Dell EMC Server Management Pack suite for Operations Manager
- Pre-requisites
- Installing Dell EMC Server Management Pack suite using .exe file
- Installing Dell EMC Server Management Pack on multiple management servers
- Upgrading from previous versions of Dell EMC Server Management Pack Suite
- Upgrading from Operations Manager 2012 R2 to Operations Manager 2016
- Upgrading from previous Operations Manager
- Using Repair option in the Dell EMC Server Management Pack suite
- Uninstalling the Dell EMC Server Management Packs
- Configuring Operations Manager to monitor Traps and Trap-Based Unit Monitors
- Dell EMC Feature Management Dashboard
- Dell EMC Server Management pack suite version 7.1 supported Monitoring features
- Dell EMC OMIMSSC version 7.1 supported monitoring features
- Troubleshooting
- Connection lost between OMIMSSC appliance and Operations Manager console
- Error message while accessing Dell EMC OMIMSSC admin portal through Mozilla Firefox browser
- Failure to connect to OMIMSSC Appliance
- Test Connection fails between Dell EMC OMIMSSC appliance and Operation Manager console
- IP address not assigned to OMIMSSC appliance
- Appliance discovery job stuck in progress state
- Unable to launch Dell EMC OMIMSSC in the Operations Manager Console
- Discovery and monitoring of the Dell EMC device fail after restarting the Dell EMC OMIMSSC
- Event ID 33333: Data Access Layer rejected retry on SqlError
- Dell EMC Feature Management Dashboard does not populate
- Feature Management Dashboard task fails
- Feature Management alerts
- Health Service of the Feature Management Host Server is nonfunctional
- Appendix
- Accessing documents from the Dell EMC support site
System requirements for OMIMSSC
Topics:
• Account privileges
•
Common system requirements for Dell EMC OMIMSSC
• Configuration planning for Management Server and Proxy MS with deployment scenarios for supported scalability
Account privileges
Requirements for the accounts used in OMIMSSC for Operations Manager.
The user must be a member of:
● Domain user group
● Local Administrator group on the Management server
● Operations Manager Admin group
Common system requirements for Dell EMC
OMIMSSC
Before setting up the Dell EMC OMIMSSC appliance, ensure that the following software prerequisites are met:
Install the Dell EMC OMIMSSC appliance using one of the following methods:
● If you are using Hyper-V, then deploy a virtual machine using .vhd file.
● If you are using VMware ESXi host version 6.5 and later, then deploy a virtual machine using .ova file.
The Dell EMC OMIMSSC appliance supports the enrollment of one Management Group through the enrollment of any of the
Management servers within the group. Following are the hardware requirements:
Table 4. Hardware requirements
Components Requirement
RAM 8 GB
Processor count 4
Hard disk 40 GB
For an Admin portal:
Install any of the following supported browsers:
1. Internet Explorer 10 or later
2. Mozilla Firefox 30 or later
3. Google Chrome 23 or later
4. Microsoft Edge
For Proxy MS, see section Proxy MS virtual machine Configuration under Configuration planning for Management
Server and Proxy MS with deployment scenarios for supported scalability and for more information, see docs.microsoft.com/.
For Gateway Servers, iDRAC should be reachable from the OMIMSSC appliance for the discovery to proceed.
3
System requirements for OMIMSSC 11