Release Notes

• Issue 4
Description: Dell EMC PowerEdge Servers that are discovered through the Dell EMC Server and Rack Workstation Monitoring feature
are shown with the default logical device icon.
Resolution: None
Version affected: Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager (Dell EMC Server and
Rack Workstation Monitoring Feature).
• Issue 5
Description: If the component is under a Software RAID controller, Inventory for Bus Type and Media Protocol in Virtual Disk are not
supported.
Resolution: Please see the iDRAC documentation for updated support.
Version affected: All
• Issue 6
Description: The Fan components of the Dell EMC PowerEdge M1000e chassis are displayed as Dell Fan.
Resolution: Upgrade the Dell EMC PowerEdge M1000e firmware to version 5.0.1
Version affected: All
• Issue 7
Description: Inventory field Manufacturer for SATA Disks may be incorrectly reported as ATA.
Resolution: None
Version affected: Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager.
• Issue 8
Description: NIC Inventory field for Virtual MAC Address are displayed as "00:00:00:00:00:00", if Virtual MAC Address has not been
configured for the NIC. This issue affects the Dell EMC Server and Rack Workstation Monitoring (Licensed) feature in version 6.3 and
the out of band or the agent-based monitoring feature of versions 6.0 and later.
Resolution: None
Version affected: Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager.
• Issue 9
Description: When Dell EMC PowerEdge M1000e chassis is discovered with controller who is inserted in slot2, and slot1 is empty, then
the value of the firmware version is displayed as Not Applicable.
Resolution: Insert the controller in SLOT1
Version affected: Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager.
• Issue 10
Description: The Deletion of devices from appliance to Operations Manager can take a long time depending on the number of devices
that are deleted at a time.
Resolution: Select small set of devices for deletion at a time. Wait for few minutes after the completion of a deletion task and then go
to trigger the next deletion.
Version affected: Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager.
• Issue 11
Description: If the unreachable IP addresses are given for discovery, then discovery for those devices runs periodically and task that is
created by OMIMSSC appliance cannot be deleted for them.
Resolution: If provided credentials are wrong, then use edit credentials profile page to correct them.
Version affected: Dell EMC OpenManage Integration v7.1 for Microsoft System Center for Operations Manager.
• Issue 12
Description: In Chassis inventory, the IP address may not be updated for the IO module.
Resolution: None
Version affected: All (Dell EMC Chassis Monitoring Feature (Detailed), Firmware 5.0.1)
• Issue 13
Description: After the reboot of appliance, monitoring will not happen until next discovery which was scheduled to be done for that
particular device. Thus, health update can take up to 24 hours to occur.
Dell EMC OpenManage Integration Version 7.1.1 for Microsoft System Center for Operations Manager (SCOM) Release Notes
9