Users Guide

Performing tasks using Dell EMC Server and Rack Workstation Monitoring
Feature
Following table provides a summary of the Dell tasks that you can perform on the Operations Manager:
Table 12. Dell Windows Server tasks
Task Description
Check Node Interfaces
Checks if the selected Dell EMC PowerEdge Server and its
corresponding interface WMI is reachable or non-reachable.
Check Power Status Check the overall power status of the system.
Clear ESM Logs Backs up the content of the Embedded System Management
(ESM) log and clears the ESM log file for a selected system.
Force Power Off Turns off the system power without shutting down the
operating system.
Get Warranty Information Retrieves the warranty information for the selected system.
NOTE: An active internet connection is required to
retrieve the warranty information.
Launch Dell License Manager on X64 bit Management Server Start the Dell license manager on management systems
running 64-bit operating system.
Launch Dell OpenManage Power Center Start the Dell OpenManage Power Center console on the
Management Server.
Launch Dell Remote Access Console Start the DRAC console for the Dell EMC PowerEdge Servers
discovered using the Server and Rack Workstation Monitoring
feature.
Launch OpenManage Server Administrator Start the OpenManage Server Administrator.
Launch Remote Desktop Start the remote desktop for the selected system.
Power Cycle Turns off the power, and after a delay, turns it on again.
Power Off Gracefully Shuts down the operating system first, and then turns off the
system power.
Power On Turns on the system power. This option is available only if the
system is turned off.
Power Reset Turns off the system power and turns it on again.
Turn LED Identification On Turns on the identify LED for 255 seconds on the selected
system.
Turn LED Identification Off Turns off the identify LED on the selected system.
Dell EMC Server Management pack suite version 7.1.1 supported Monitoring features 41