Users Guide

NOTE: Informational alerts are turned o by default. To receive these alerts, import informational alerts management
pack.
Tasks
Tasks are available in the Tasks pane of the OpsMgr console. When you select a device or a component, the relevant tasks appear in the
Tasks pane.
Task summary
Performing tasks using DRAC
Following table provides a summary of the tasks that are performed using the DRAC:
Table 25. Tasks using DRAC
Task Description
Check Node Interfaces Checks if the selected Dell DRAC/iDRAC device and its
corresponding interface; SNMP is reachable or non-reachable.
Launch Dell License Manager Launches the Dell License manager on the management system.
Launch Dell Remote Access Console Launches the DRAC console for the discovered DRAC.
Launch Remote Desktop Launches the remote desktop for the selected system.
NOTE: This feature is available only on systems with
iDRAC7, and iDRAC8.
Launch Server Administrator Launches the Server Administrator.
NOTE:
• Server Administrator console is launched only if the
Server Administrator is congured on the default port.
• This feature is available only on systems with iDRAC7,
and iDRAC8.
Dell Remote Access Controller (DRAC) tasks
Check Node Interfaces
The Check Node Interfaces task checks if the selected Dell DRAC/iDRAC device and its corresponding interface; SNMP is reachable or
non-reachable.
To check the node interfaces:
1 In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2 Select the desired Dell DRAC/iDRAC in any of the Dell Diagram Views, State Views, or an alert in the Alerts Views.
3 In the Tasks pane, select Dell Remote Access Controller Tasks > Check Node Interfaces.
78
DRAC Monitoring Feature