Install Guide

○ R750xa
○ R650
○ C6520
○ MX750c
○ R450
○ R550
○ R650xs
○ R750xs
● Support for PowerEdge RAID Controllers (PERC), series 9 and 10 for Dell EMC systems are:
○ PERC H745
○ PERC H345
○ PERC H840
○ HBA345
○ HBA330 MMZ
○ PERC H745P MX
● The set and get iDRAC configuration using .INI file (dependent on RACADM deprecated feature) is not supported with
iDRAC version 4.40.40.00 or later. Use XML input file to configure iDRAC.
NOTE: No additional upgrade to the DSDP is required to support the latest iDRAC 9-based PowerEdge servers. Use the
provided DTK v6.4 with your installed DSDP 4.1.
Pre-requisites and requirements
NOTE:
This document contains information about requirements and the supported software necessary for installing Dell
EMC Server Deployment Pack (DSDP) and this document is packaged in the DSDP installable. When you are installing this
version of DSDP after a long time after its release date, check to see if there is an updated version of this document on the
support site. For accessing documents on support site, see Dell.com/support/home.
● Before you begin configuring the server, ensure that you have set up the server and the environment by using either one
of the following System Center Configuration Manager(SCCM)/Microsoft Endpoint Configuration Manager (MECM)
updates:
○ Update 2103 for Configuration Manager
○ Update 2010 for Configuration Manager
○ Update 2006 for Configuration Manager
○ Update 2002 for Configuration Manager
○ Update 1910 for Configuration Manager
○ Update 1906 for Configuration Manager
○ Update 1810 for Configuration Manager
○ System Center Configuration Manager 2016
○ System Center Configuration Manager 2012
For details on how to download and install Configuration Manager, go to the Microsoft TechNet site at
technet.microsoft.com
● Ensure to install all the features of Windows Automation Install Kit (WAIK) or Windows Assessment and Deployment Kit
(ADK). For more information about versions, see the Microsoft Windows AIK or Windows ADK documentation.
● Ensure the supported DTK versions is installed. For more information, see Configuration Manager, operating system,
DTK, AIK/ADK support matrix for Dell EMC Server Deployment Pack.
NOTE:
The DTK version 6.4.0 contained in the package is only supported for Dell EMC Server Deployment Pack (DSDP)
not otherwise. Using this version of DTK outside of DSDP is not supported.
NOTE: For more information about the latest iDRAC9 based PowerEdge servers, see idrac9-based PowerEdge servers .
The PowerEdge servers other than the list of iDRAC9 based platforms are supported.
Overview 5