Users Guide
Table Of Contents
- Dell EMC Server Deployment Pack Version 4.0 for Microsoft System Center Configuration Manager User's Guide
- Contents
- Introduction
- Before using Configuration Manager
- Using the Dell EMC Server Deployment Pack on systems running System Center Configuration Manager, 2012 SP2, 2012 R2 SP1, 2012 R2, 2012 SP1, or 2012
- Dell Driver CAB files
- Importing Dell Driver CAB files for creating boot image
- Upgrading Dell Driver CAB files
- Customizing boot image and deploying OS through Dell Driver CAB files
- Creating a boot image for deploying PowerEdge servers
- Enabling command prompt for debugging boot images
- Distributing content and updating distribution points
- Configuring the task sequence steps to apply operating system image and driver package
- Deploying a task sequence
- Dell Deployment ToolKit
- Importing a DTK package for hardware configuration and OS deployment
- Upgrading a DTK package
- Customizing boot image, configuring hardware and deploying OS through DTK
- System Lockdown Mode
- Configuring the hardware components of your server
- Configuring task sequence actions
- Using the Array Builder
- Creating task sequences for RAID, DRAC, and iDRAC
- Importing Dell Server Driver Packages
- Dell Driver CAB files
- Troubleshooting
- Command line options
- Other Dell documents you might need
NOTE:
● In Configuration Manager 2012 SP1, there are only Windows PE 4.0 drivers, so only 64–bit operating systems'
deployment is supported as DTK version 5.5 does not support 32–bit version of Windows PE 4.0 drivers.
● In Configuration Manager 2012, there is only Windows PE 3.x drivers, so both 32–bit and 64–bit operating systems'
deployments are supported as DTK version 5.5 supports 32–bit version and 64–bit version of Windows PE 3.x drivers.
● For 14th generation of PowerEdge servers, use DTK version 6.0.1.
● For 10th generation to 13th generation of PowerEdge servers, use DTK version 5.5.
Before using Configuration Manager 7