Install Guide

Table 6. AC power requirements
Parameter Specifications
Power supply 100–240 VAC 50/60 Hz
Typical current draw per platform
● 16 core: 110 VAC: 1.89 A
● 8 core: 110 VAC: 1.62 A
● 16 core: 240 VAC: 0.87 A
● 8 core: 240 VAC: 0.75 A
Typical power consumption
● 16 core processor with five fans: 208 W
● 8 core processor with four fans: 178 W
Maximum power consumption
● 16 core processor with five fans 312 W
● 8 core processor with four fans: 242 W
IEEE standards
The Edge 3000 Series complies with the following IEEE standards:
● 802.1ab—LLDP
●
802.1ax—Layer 2
● 802.1d, 802.1w, 802.1s, 802.1x—Mgmt/Security; 802.3x—Layer 2
● 802.3—1000BASE-KX
● 25G Etherenet Consortium 25
Agency compliance
The Edge 3000 Series complies with the following safety and agency requirements:
USA Federal Communications Commission statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and
used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures
necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell EMC is not
responsible for any radio or television interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications in the equipment. Unauthorized changes or modification could void the user’s authority
to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Figure 2. Canadian Department of Communication Statement
32
Specifications