Install Guide
Table Of Contents
- Dell EMC SD-WAN Edge 3000 Series Installation Guide
- Disclaimer for Third Party Content
- About this guide
- Edge 3000 Series
- Site preparations
- Edge 3000 Series installation
- Platform setup
- Power supplies
- Fans
- Management ports
- User interface
- Specifications
- Dell EMC support
User interface
The Edge 3000 Series user interface (UI) includes local web pages—Overview, Properties, and Reset Settings—that provide
troubleshooting functions and information about the interfaces.
Access the Edge 3000 Series UI at https://edge.velocloud.net, or at the IP address 192.168.2.1.
NOTE: Use the UI only for initial configuration and troubleshooting when the Internet is not available. Do not use the
Edge 3000 Series UI during normal operations because the information and configurations are available using the VMware
SD-WAN Orchestrator. By default, LAN access to this interface is blocked after you activate your Edge 3000 Series
platform.
Overview
The Overview page provides the status of the routed interfaces (WAN) and switched interfaces (LAN) connections.
The top half of the screen displays a diagram of the device. If connections are active, green indicator lights display on the
hardware diagram. On the Overview page, next to the device image are two buttons, Overview and Details. To display WAN
and LAN connection status information, click Details.
Underneath the device diagram, the status of the WAN and LAN connections display. In this area, you can change the display by
clicking the Connected, Both, or Unconnected buttons.
If you click a WAN connection, a properties page for that connection opens.
NOTE:
You can also download a diagnostic bundle from the Overview page by clicking the Download Diagnostic Bundle
button. Open the Reset Settings page by clicking the Reset Settings button.
9
User interface 29