Support Matrix
Table Of Contents
- Dell EMC PowerVault ME4 Series Storage System Support Matrix
- Introduction
- Supported data protocols
- Dell EMC PowerVault ME4 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI SFP+ transceivers
- Supported SAS and Twinax direct-attach cables
- Supported physical disk drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- Dell EMC Storage Support Policy
Default IPv4 Settings for management ports
NOTE: No default gateway is set.
By default, the management ports on the storage system are set to DHCP. If DHCP fails, the following IPv4 settings are used:
Table 5. Default IPv4 Management Port Addresses
Controller/Port IPv4 Address Subnet Mask
Controller 0 10.0.0.2 255.255.255.0
Controller 1 10.0.0.3 255.255.255.0
4
Default IPv4 Settings for management ports 11