CLI Guide

show initiators
remove host-members
Description Removes specified initiators from a host. You cannot remove all initiators from a host. At least one initiator
must remain. The initiators are ungrouped but not deleted.
Minimum role manage
Syntax
remove host-members
initiators initiators
host-name
Parameters
initiators initiators
A comma-separated list of the names of initiators to remove from the host. A name that includes a space
must be enclosed in double quotes.
host-name
The name of the host. A name that includes a space must be enclosed in double quotes.
Examples Remove two initiators from a group that contains three initiators.
# remove host-members initiators FC-init2,FC-init3 FC-host11
See also
delete hosts
show initiators
remove ipv6-address
Description
Removes a static IPv6 address from a controller network port.
NOTE: When the set ipv6-network-parameters command's autoconfig parameter is disabled,
you cannot remove the last IPv6 address.
Minimum role manage
Syntax
remove ipv6-address
[address-label name]
[controller a|b]
[index index]
[ip-address IP-address]
Parameters The parameters must be used in one of these ways:
• controller & index
• controller & address-label
• IP address
address-label name
Optional. Specifies the name assigned to the address.
controller a|b
Optional. Specifies whether to change controller A or B, only. If this parameter is omitted, changes affect the
controller being accessed.
index index
Optional. A value from 0 to 3 that specifies the controller's index value for the address.
88 Alphabetical list of commands