CLI Guide

Minimum role manage
Syntax
delete pools
[prompt yes|no]
pools
Parameters
[prompt yes|no]
Optional. For scripting, this specifies an automatic reply to confirmation prompts:
• yes: Allow the command to proceed.
• no: Cancel the command.
If this parameter is omitted, you must manually reply to prompts.
pools
A comma-separated list of the names or serial numbers of the pools to delete. For a linear pool, a name that
includes a space must be enclosed in double quotes.
Examples Delete virtual pool A.
# delete pools A
Delete linear pool dg1.
# delete pools dg1
See also
delete vdisks
remove disk-groups
show pools
show vdisks
delete remote-system
Description
Deletes the persistent association with a remote system. This command applies to linear storage only.
NOTE: Remote-system connections for linear replication are not supported for virtual
replication. Instead you must create peer connections.
Minimum role manage
Syntax
delete remote-system
system
Parameters
system
The name or network-port IP address of the remote system. A name that includes a space must be enclosed
in double quotes. The value can be an IPv4 address, IPv6 address, or FQDN.
Examples Delete remote system System2.
# delete remote-system System2
See also show remote-systems
delete replication-set
Description
Deletes a replication set. This command applies to virtual storage only.
You can run this command on the replication set’s primary or secondary system.
70 Alphabetical list of commands