CLI Guide

Table 104. security-communications-protocols properties (continued)
Name Type Description
• 1: Enabled
inband-ses string
• Disabled : The in-band SES interface is disabled.
• Enabled : The in-band SES interface is enabled.
inband-ses-numeric uint32 Numeric equivalents for inband-ses values.
• 0: Disabled
• 1: Enabled
activity-progress string
• Enabled : Access to the activity progress interface via HTTP port 8081 is enabled.
This mechanism reports whether a firmware update or partner firmware update
operation is active and shows the progress through each step of the operation. In
addition, when the update operation completes, status is presented indicating either
the successful completion, or an error indication if the operation failed.
• Disabled : Access to the activity progress interface via HTTP port 8081 is
disabled.
management-mode string The default management mode.
• Linear : Uses linear-storage terminology in command output and system
messages. For example, vdisk for disk groups and pools.
• Virtual : Uses terminology in command output and system messages that is
generalized for managing virtual and linear storage. For example, disk group for
disk groups and pool for pools.
management-mode-numeric uint32 Numeric equivalents for management-mode values.
• 2: Linear
• 3: Virtual
activity-progress-numeric uint32 Numeric equivalents for activity-progress values.
• 0: Disabled
• 1: Enabled
sensors
This basetype is used by show sensor-status on page 233.
Table 105. sensors properties
Name Type Description
durable-id string Sensor ID.
enclosure-id uint32 Enclosure ID.
drawer-id
(5U84 enclosure)
uint8
• 0 : Top
• 1 : Bottom
drawer-id
(2U12/24 enclosure)
uint8 Not applicable ( 255 ).
controller-id string
• A : Controller A.
• B : Controller B.
• both : Both controllers.
• N/A
controller-id-numeric uint32 Numeric equivalents for controller-id values.
390 API basetype properties