CLI Guide

Table 75. network-parameters properties (continued)
Name Type Description
duplex-mode string
• Undefined: For a system operating in Single Controller mode, this controller
module is not present.
• Half: The network port duplex mode is set to half duplex.
• Full: The network port duplex mode is set to full duplex.
duplex-mode-numeric uint32 Numeric equivalents for duplex-mode values.
• 0: full
• 1: half
• 2: Undefined
health string The health of the network connection.
• OK
• Degraded
• Fault
• N/A
• Unknown
health-numeric uint32 Numeric equivalents for health values.
• 0: OK
• 1: Degraded
• 2: Fault
• 3: Unknown
• 4: N/A
health-reason string If Health is not OK, the reason for the health state.
health-recommendation string If Health is not OK, the recommended actions to take to resolve the health issue.
ping-broadcast string
• Enabled: The system will respond to a broadcast ping.
Disabled: The system will not respond to a broadcast ping.
ping-broadcast-numeric uint32
Numeric equivalents for ping-broadcast values.
• 0: Disabled
• 1: Enabled
ntp-status
This basetype is used by show ntp-status on page 211.
Table 76. ntp-status properties
Name Type Description
ntp-status string Shows whether use of Network Time Protocol (NTP) is enabled.
• activated: NTP is enabled.
• deactivated: NTP is disabled.
ntp-server-address string
• The current NTP server IP address if NTP is enabled.
• The last-set NTP server IP address if NTP was enabled and has been disabled.
• 0.0.0.0 if the NTP server IP address has not been set.
ntp-contact-time string (UTC), of the last message received from the NTP server.
API basetype properties 363