CLI Guide

Table 46. expander-ports properties (continued)
Name Type Description
name string
• Out Port: Egress (expansion) port on controller module or an expansion module.
Can be connected to an ingress port in an expansion module.
• In Port: Ingress port on an expansion module. Can be connected to an egress
(expansion) port in a controller module or an expansion module.
• Universal Port: Port that can function as either an egress or ingress port in a
controller module or an expansion module.
status string Expander port status.
• Up: The port is cabled and has an I/O link.
• Warning: Not all of the port PHYs are up.
• Error: The port is reporting an error condition.
• Not Present: The controller module is not installed or is down.
• Disconnected: Either no I/O link is detected or the port is not cabled.
status-numeric uint32 Numeric equivalents for status values.
• 0: Up
• 1: Warning
• 2: Error
• 3: Not Present
• 4: Unknown
• 6: Disconnected
health string
• OK
• Degraded
• Fault
• N/A
• Unknown
health-numeric uint32
Numeric equivalents for health values.
• 0: OK
• 1: Degraded
• 2: Fault
• 3: Unknown
• 4: N/A
health-reason string If Health is not OK, the reason for the health state.
health-recommendation string If Health is not OK, the recommended actions to take to resolve the health issue.
expander-versions
This basetype is used by show versions on page 258 when the frus parameter is specified.
Table 47. expander-versions properties
Name Type Description
name string Expansion IOM name in the format IOM enclosure-ID, position.
location string Expander location in the format Enclosure enclosure-ID, IOM I/O-module- ID.
enclosure-id uint32 Enclosure ID.
drawer-id uint8
• 0: Top
• 1: Bottom
340 API basetype properties