CLI Guide

Table 12. cli-parameters properties (continued)
Name Type Description
• Virtual: Uses terminology in command output and system messages that is
generalized for managing virtual and linear storage. For example, disk group for
disk groups and pool for pools.
management-mode-numeric uint32 Numeric equivalents for management-mode values.
• 2: Linear
• 3: Virtual
cloud-iq
This basetype is used by show cloudiq on page 168.
Table 13. chap-records properties
Name Type Description
cloud-iq string Shows whether the ability to remotely monitor the system by using the Dell EMC
CloudIQ application is enabled or disabled.
• Enabled: Use of the CloudIQ application is enabled.
• Disabled: Use of the CloudIQ application is disabled.
cloud-iq-numeric unit32 Numeric equivalents for cloud-iq values.
• 0: Disabled
• 1: Enabled
cloudiq-last-logssend-status string Specifies the status of the last transmission of storage system configuration data to the
support server.
cloudiq-last-logssend-time string Specifies the date/time of the last transmission of storage system configuration data to
the support server.
cloudiq-lastconfig-send-
timenumeric
unit32 Unformatted cloudiq-last-config-send-time value.
cloudiq-last-perfsend-status string Specifies the status of the last transmission of storage system performance data to the
support server.
cloudiq-last-perfsend-time string Specifies the date/time of the last transmission of storage system performance data to
the support server.
cloudiq-last-perfsend-time-
numeric
unit32 Unformatted cloudiq-last-perf-send-time value.
code-load-readiness
This basetype is used by check firmware-upgrade-health on page 37.
Table 14. code-load-readiness properties
Name Type Description
overall-health string
• Pass: There are no risks to performing firmware upgrade.
• Fail: At least one condition exists that presents a risk of upgrade failure or loss of
availability.
overall-health-numeric uint32 Numeric equivalents for overall-health values.
• 0: Pass
• 1: Fail
API basetype properties 291