CLI Guide

• VerifySnap
• InspectRetention
• FindOldestSnap
• UnmapSnap
• ResetSnap
• RenameSnap
Error Message
• If an error occurred while processing the task, the error message.
• Blank if no error has occurred.
Source Volume
The name of the source volume.
Source Volume Serial
The serial number of the source volume.
Prefix
The label that identifies snapshots created by this task.
Retention Count
The number of snapshots to retain with this prefix. When a new snapshot exceeds this limit, the oldest
snapshot with the same prefix is deleted.
Last Created
• The name of the last snapshot created by the task.
• Blank if the task has not taken a snapshot.
Snapshot Name
• The name of each snapshot taken.
• Blank if the task has not taken a snapshot.
Snapshot Serial
• The serial number of each snapshot taken.
• Blank if the task has not taken a snapshot.
ResetSnapshot task, detail
Task Name
The name of the task.
Task Type
TakeSnapshot
ResetSnapshot
Status
• Uninitialized: The task is not yet ready to run.
• Ready: The task is ready to run.
• Active: The task is running.
• Error: The task has an error.
• Deleted: The task is expired but this state is not yet synchronized to the partner controller.
Task State
The current step of the task:
• Start
• VerifySnap
• UnmapSnap
• ResetSnap
Error Message
Alphabetical list of commands
245