CLI Guide

IP Address Controller B
The IP address of the network port in controller B in the remote system.
Username
The name of a user with the manage role in the remote system.
Status
• Uninitialized: This system hasn’t communicated with the remote system.
• Ready: This system has contacted the remote system and it is ready to use.
• Connected: This system is transferring data to the remote system.
• Not Connected: The system is not connected to the remote system.
Last Connected
Date and time, in the format year-month-day hour:minutes:seconds (UTC), when successful
communication was last established between the Management Controller in the local system and the
Management Controller in the remote system. This value does not indicate when connection status was last
determined, and will not be updated if the remote Management Controller is not accessible or if the
connection status is Not Connected.
Examples Show information about remote system System2.
# show remote-systems System2
Basetypes
remote-system
status
See also delete remote-system
show replication-sets
Description
Shows information about replication sets in the peer connection. This command applies to virtual storage
only. You can view information about all replication sets or a specific replication set.
For virtual storage, you can run this command on either the primary or secondary system. In console mode,
this command does not show the serial numbers of items such as replication volumes. To see serial numbers,
run this command in API mode.
Timestamps use the local time zone of the system on which this command is run.
NOTE: If you change the time zone of the secondary system in a replication set whose primary
and secondary systems are in different time zones, you must restart the system to enable
management interfaces to show proper time values for replication operations.
Properties shown only in API output are described in API basetypes properties
Minimum role monitor
Syntax
show replication-sets
[replication-set-ID]
Parameters
replication-set-ID
Optional. The name or serial number of a replication set for which to display information at the replication set
level. A name that includes a space must be enclosed in double quotes. If this parameter is omitted,
information is shown for all replication sets.
Output
Overview information:
Name
The replication set name.
Group
228 Alphabetical list of commands