CLI Guide

• Incorrect protocol: The SFP protocol does not match the port protocol. When this condition is
detected, event 464 is logged.
Part Number
If the detail parameter is specified, this field shows the SFP part number.
Supported Speeds
FC only. If the detail parameter is specified, this field shows the link speeds that the SFP supports.
10G Compliance
iSCSI only. If the detail parameter is specified, this field shows the SFP's 10G compliance code. If the SFP
returns an unsupported code, this field will show the equivalent hex value.
Ethernet Compliance
iSCSI only. If the detail parameter is specified, this field shows the SFP's Ethernet compliance code. If the
SFP returns an unsupported code, this field will show the equivalent hex value.
Cable Technology
iSCSI only. If the detail parameter is specified, this field shows whether the SFP supports active or passive
cable technology.
Cable Length
iSCSI only. If the detail parameter is specified, this field shows the link length (in meters) that is supported
by the SFP while operating in compliance with applicable standards for the cable type.
Examples Show information about host ports in each controller module.
# show ports
Show detailed information about host ports in each controller module.
# show ports detail
Basetypes
port
status
See also set host-parameters
show power-supplies
Description
Shows information about each power supply in the storage system.
Minimum role monitor
Syntax show power-supplies
Output
Encl
The ID of the enclosure that contains the power supply.
Id
The power supply position, shown as an index value that starts at 0 and increments from left to right as
viewed from the back of the enclosure
Serial Number
The serial number of the power supply.
Part Number
• (blank): Not applicable.
Name
The power supply identifier and location.
Firmware Version
Alphabetical list of commands 221