CLI Guide

• 0.0.0.0 if the NTP server IP address has not been set.
Last Server Contact
The date and time in the format year-month-day hour:minutes:seconds of the last message
received from the NTP server, or none.
Examples Show NTP status for the system.
# show ntp-status
Basetypes
ntp-status
status
See also set controller-date
show peer-connections
Description Shows information about a peer connection between two systems. You can run this command on either the
local or remote system.
Minimum role monitor
Syntax
show peer-connections
[verify-links]
peer-connection-ID
Parameters
[verify-links]
Optional. If a peer connection ID is specified, this parameter displays the ports that can be seen by each port
on each peer system.
peer-connection-ID
Optional. Specifies the name or serial number of the peer connection for which to show information. If this
parameter is not specified the command shows information for all peer connections.
Output
Peer Connection Name
The name of the peer connection.
Peer Connection Type
The type of ports being used for the peer connection:
• FC: FC ports.
• iSCSI: iSCSI ports.
Connection Status
• Online: The systems have a valid connection.
• Offline: No connection is available to the remote system.
Health
• OK
• Fault
• Unknown
Health Reason
If Health is not OK, this field shows the reason for the health state.
Health Recommendation
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Local Port
The IDs of ports in the local system.
212
Alphabetical list of commands