CLI Guide

• DHCP: DHCP is used to set network parameters.

Link Speed

• Unknown: For a system operating in Single Controller mode, this controller module is not present.

• 10mbps: The network port link speed is set to 10 Mb/s.

• 100mbps: The network port link speed is set to 100 Mb/s.

• 1000mbps: The network port link speed is set to 1000 Mb/s.

Duplex Mode

• Undefined: For a system operating in Single Controller mode, this controller module is not present.

• half: The network port duplex mode is set to half duplex.

• full: The network port duplex mode is set to full duplex.

Auto Negotiation

• Disabled: Either the network port has not been set, or it has been unset because the controller module

was removed from its enclosure, or the port is connected to a switch and is set to use the link speed and

duplex mode shown by the Link Speed and Duplex Mode fields.

• Enabled: The network port is set to auto-negotiate a link speed (up to the maximum speed shown by

the Link Speed field) and duplex mode with a connected Ethernet switch.

Health

The health of the network connection.

• OK

• Degraded

• Fault

• N/A

• Unknown

Health Reason

If Health is not OK, this field shows the reason for the health state.

Health Recommendation

If Health is not OK, this field shows recommended actions to take to resolve the health issue.

Examples

Show network parameters for each controller module.

# show network-parameters

Basetypes

network-parameters

status