CLI Guide

The iSCSI host port link speed.
• auto: The proper speed is auto-negotiated.
• 1Gbps: The speed is forced to 1 Gbit/s, overriding a downshift that can occur during auto-negotiation
with 1-Gbit/s HBAs. This setting does not apply to 10-Gbit/s HBAs.
iSCSI IP Version
• 4: iSCSI host port addresses use IPv4 format.
• 6: iSCSI host port addresses use IPv6 format.
Examples Show system-wide parameters for iSCSI ports.
# show iscsi-parameters
Basetypes
iscsi-parameters
status
See also set iscsi-parameters
show license
Description Shows the status of licensed features in the storage system.
Minimum role monitor
Syntax
show license
Output
License Key
The license key, licensing serial number, and status of licensed features. All licensed features are enabled.
show maps
Description
Shows information about mappings between volumes and initiators. If no parameter is specified, this
command shows explicit mappings (but not default mappings) for all volumes.
In a dual-controller system, if a mapping uses corresponding ports on both controllers, such as A1 and B1, the
Ports field will simply show 1.
Minimum role monitor
Syntax
show maps
[all]
[initiator]
[IDs]
Parameters
all
Optional. Shows mappings of all access types: read-write, read-only, no-access, and not-mapped (default
mappings). If this parameter is omitted, mappings of type not-mapped are not shown.
initiator
Optional. Shows mapping information by initiator. If this parameter is omitted, mapping information is shown
by volume.
IDs
Optional. A comma-separated list of the names or serial numbers of host-type items (initiators, hosts, and
host groups) or volume-type items (volumes and volume groups) for which to show mappings. If a volume is
mapped to a host group, to see mappings you must specify the host group, not a host or initiator in the
group. If a volume is mapped to a host, to see mappings you must specify the host, not an initiator in the
group.
208 Alphabetical list of commands