CLI Guide

Output
Autoconfig
• enabled: Uses an IPv6 address computed by SLAAC or assigned by a DHCPv6 server, depending on
the network configuration. If a DHCPv6 address is available, then that address is used. Otherwise SLAAC
is used.
• disabled: Uses static IPv6 addresses set with the add ipv6-address command.
Gateway
The network port gateway IPv6 address.
Link-Local Address
The link-local IPv6 address.
Autoconfig IP
The automatically configured IPv6 address.
IPv6 Address (1-4)
Shown if Autoconfig is disabled. Shows between one and four manually set IPv6 addresses.
IPv6 Label (1-4)
Shown if Autoconfig is disabled. Shows the user-defined name, if set, for each manual IPv6 address.
Examples Show IPv6 network parameters for each controller module.
# show ipv6-network-parameters
Basetypes
ipv6-network-parameters
status
See also
set ipv6-network-parameters
show iscsi-parameters
Description
Shows system-wide parameters for iSCSI host ports in each controller module.
Minimum role monitor
Syntax
show iscsi-parameters
Output CHAP
Shows whether Challenge-Handshake Authentication Protocol (CHAP) is enabled or disabled.
• Enabled: CHAP is enabled.
• Disabled: CHAP is disabled.
Jumbo Frames
Shows whether support for jumbo frames is enabled or disabled.
• Enabled: Jumbo-frame support is enabled.
• Disabled: Jumbo-frame support is disabled.
iSNS
Shows whether support for Internet Storage Name Service (iSNS) is enabled or disabled.
• Enabled: iSNS support is enabled.
• Disabled: iSNS support is disabled.
iSNS IP
The address of the iSNS server. The default address is all zeroes.
iSNS Alt IP
The address of the alternate iSNS server. The default address is all zeroes.
iSCSI Speed
Alphabetical list of commands 207