CLI Guide

[initiators]
Parameters
hosts hosts
Optional. A comma-separated list of the names of hosts containing initiators for which to show information. If
this parameter is omitted, information is shown for all initiators.
initiators
Optional. A comma-separated list of the names of initiators for which to show information. If this parameter is
omitted, information is shown for all initiators.
Output
Nickname
The name of the initiator.
Discovered
• Yes: The initiator was discovered and its entry was automatically created.
• No: The initiator was manually created.
Mapped
Shows whether the initiator is explicitly mapped to any volumes:
• Yes: At least one volume is explicitly mapped to the initiator.
• No: No volumes are explicitly mapped to the initiator.
Profile
Standard: Default profile.
Host Type
The host-interface type: FC; iSCSI; SAS.
ID
For an FC initiator, its WWPN. For a SAS initiator, its WWPN. For an iSCSI initiator, its node name (typically
the IQN).
Examples Show information about all initiators.
# show initiators
Show information about initiators in host Host1 only.
# show initiators hosts Host1
Basetypes
status
initiator
See also
delete initiator-nickname
set initiator
show host-groups (with the hosts parameter)
show inquiry
Description
Shows inquiry data for each controller module.
Minimum role monitor
Syntax show inquiry
Output
• Product vendor name, product ID, vendor ID, and SCSI product ID
• Management Controller firmware version and loader version
• Storage Controller firmware version and loader version
• Controller module serial number
Alphabetical list of commands 205