CLI Guide

Reads
The number of read operations since these statistics were last reset or since the controller was restarted.
Writes
The number of write operations since these statistics were last reset or since the controller was restarted.
Data Read
The amount of data read since these statistics were last reset or since the controller was restarted.
Data Written
The amount of data written since these statistics were last reset or since the controller was restarted.
Queue Depth
The number of pending I/O operations being serviced.
I/O Resp Time
The average response time in microseconds for read and write operations, calculated over the interval since
these statistics were last requested or reset.
Read Resp Time
The average response time in microseconds for all read operations, calculated over the interval since these
statistics were last requested or reset.
Write Resp Time
The average response time in microseconds for all write operations, calculated over the interval since these
statistics were last requested or reset.
Reset Time
The date and time, in the format year-month-day hour:minutes:seconds, when these statistics
were last reset, either by a user or by a controller restart.
Examples
Show live performance statistics for all host ports.
# show host-port-statistics
Show live performance statistics for host port A1.
# show host-port-statistics ports a1
Basetypes
host-port-statistics
status
See also
reset all-statistics
show host-port-statistics
show host-phy-statistics
show ports
show initiators
Description
Shows information about initiators. The command will show information about all initiators by default, or you
can use parameters to filter the output.
Initiator entries are automatically created for host initiators that have sent an inquiry command or a
report luns command to the system. This typically happens when the physical host containing an initiator
boots up or scans for devices. When the command is received, the system saves the host port information.
However, the information is retained after a restart only if you have set a name for the initiator.
Minimum role monitor
Syntax
show initiators
[hosts hosts]
204 Alphabetical list of commands