CLI Guide

Number of Members
The number of hosts in the host group.
Host information:
Name
The host name.
Number of Members
The number of initiators in the host.
Initiator information:
Nickname
The nickname of the initiator.
Discovered
• Yes: The initiator was discovered and its entry was automatically created.
• No: The initiator was manually created
Mapped
Shows whether the initiator is explicitly mapped to any volumes:
• Yes: At least one volume is explicitly mapped to the initiator.
• No: No volumes are explicitly mapped to the initiator.
Profile
Standard: Default profile.
ID
For an FC initiator, its WWPN. For a SAS initiator, its WWPN. For an iSCSI initiator, its node name (typically
the IQN).
Examples
Show information about all host groups.
# show host-groups
Show information about host groups HGroup1 and HGroup3.
# show host-groups groups HGroup1,HGroup3
Basetypes
host-group
status
See also
create host-group
delete host-groups
set host-group
show host-phy-statistics
Description
Shows diagnostic information relating to SAS controller physical channels, known as PHY lanes, for each host
port.
This command shows PHY status information for each host port found in an enclosure. Each controller in an
enclosure may have multiple host ports. A host port may have multiply PHYs. For each PHY, this command
shows statistical information in the form of numerical values.
There is no mechanism to reset the statistics. All counts start from the time the controller started up. The
counts stop at the maximum value for each statistic.
This command is only applicable to systems that have controllers with SAS host ports.
Minimum role monitor
202 Alphabetical list of commands