CLI Guide

• Drive removed: PHY disabled because drive slot is empty.
• Unused - disabled by default: PHY is disabled by default because it is not used.
• Excessive Phy changes: PHY is disabled because of excessive PHY change counts.
• Did not initialize
Examples Show expander status for each enclosure.
# show expander-status
Basetypes
sas-status-controller-a
sas-status-drawer
status
See also
clear expander-status
set expander-fault-isolation
set expander-phy
show fan-modules
Description
Shows information about each fan module in the storage system.
To see information about both fans in each fan module, use the show fans command
Minimum role monitor
Syntax
show fan-modules
Output
Encl
The ID of the enclosure that contains the fan module.
Id
The fan module position, shown as an index value that starts at 0 and increments from left to right as viewed
from the back of the enclosure.
Name
The name of the fan module in the format Fan Module ID.
Health
• OK
• Degraded
• Fault
• N/A
• Unknown
Reason
If Health is not OK, this field shows the reason for the health state.
Action
If Health is not OK, this field shows recommended actions to take to resolve the health issue
Examples Show about all fan modules in the system.
# show fan-modules
Basetypes
fan-modules
status
See also
show fans
196 Alphabetical list of commands