CLI Guide

○ INFORMATIONAL: A configuration or state change occurred, or a problem occurred that the system
corrected. No action is required.
○ RESOLVED: A condition that caused an event to be logged has been resolved.
• Event-specific message giving details about the event.
Examples Show the last two events.
# show events last 2
Show the last three non-Informational events.
# show events last 3 error
Show all events from April 30 2014 at 11:59:00 p.m. through May 2 2014 at 11:59:00 a.m.
# show events from 043014235900 to 050214115900
Show a range of events logged by controller A.
# show events from-event a100 to-event a123
Show detailed output for a specific event.
# show events from-event A2264 to-event A2264 detail
Basetypes
events
eventsLogs
status
See also
clear events
set snmp-parameters
show snmp-parameters
show expander-status
Description
Shows diagnostic information relating to SAS Expander Controller physical channels, known as PHY lanes.
NOTE: This command is for use by or with direction from technical support.
For each enclosure, this command shows status information for PHYs in I/O module A and then I/O module B
Minimum role monitor
Syntax
show expander-status
Output
Encl
The enclosure that contains the SAS Expander.
Drawer
Shown in drawer output. The number of the drawer.
Expander
Shown in drawer output. The number of the Expander.
Ctlr
The I/O module that contains the SAS Expander.
Phy
Identifies the logical location of a PHY within a group based on the PHY type. If the controller module or
expansion module for the PHY is not installed, this field shows “--”.
phy phy-ID
The logical PHY number.
Type:
194 Alphabetical list of commands