CLI Guide

[to-event event-ID]
Parameters
a|b|both|error
Optional. Specifies to filter the event listing:
• a: Shows events from controller A only. Do not use this parameter with the from-event parameter or
the to-event parameter.
• b: Shows events from controller B only. Do not use this parameter with the from-event parameter or
the to-event parameter.
• both: Shows events from both controllers. Do not use this parameter with the from-event parameter
or the to-event parameter.
• error: Shows Warning, Error, and Critical events, but not Informational or Resolved events.
detail
Optional. Shows additional information and recommended actions for displayed events.
from timestamp
Optional. Shows events that occurred on or after a timestamp specified with the format MMDDYYhhmmss.
For example, 043011235900 represents April 30 2011 at 11:59:00 p.m. This parameter can be used with the
to parameter or the to-event parameter.
from-event event-ID
Optional. Shows events including and after the specified event ID. If this number is smaller than the ID of the
oldest event, events are shown from the oldest available event. Events are shown only for the controller that
the event ID specifies (A or B). This parameter can be used with the to parameter or the to-event
parameter.
last #
Optional. Shows the latest specified number of events. If this parameter is omitted, all events are shown.
logs yes|no
Optional.
• no: Lists events as described in the Output section, below. This is the default.
• yes: Shows events in tabular format, with columns for event ID, date and time, event code, severity, and
message.
to timestamp
Optional. Shows events that occurred on or before a timestamp specified with the format MMDDYYhhmmss.
For example, 043011235900 represents April 30 2011 at 11:59:00 p.m. This parameter can be used with the
from parameter or the from-event parameter.
to-event event-ID
Optional. Shows events before and including the specified event ID. If this number is larger than the ID of the
oldest event, events are shown up to the latest event. Events are shown only for the controller that the
event ID specifies (A or B). This parameter can be used with the from parameter or the from-event
parameter.
Output
• Date and time when the event was logged.
• Event code identifying the type of event to help diagnose problems. For example: [3]
• Event ID prefixed by A or B, indicating which controller logged the event. For example: #A123
• Model, serial number, and ID of the controller module that logged the event.
• Severity:
○ CRITICAL: A failure occurred that may cause a controller to shut down. Correct the problem
immediately.
○ ERROR: A failure occurred that may affect data integrity or system stability. Correct the problem as
soon as possible.
○ WARNING: A problem occurred that may affect system stability but not data integrity. Evaluate the
problem and correct it if necessary.
Alphabetical list of commands 193