CLI Guide

show enclosures
Description
Shows information about the enclosures in the storage system. Full detail available in API output only.
If a connected expansion enclosure is not supported, it will not be listed and events 315 and 443 will be
logged.
Minimum role monitor
Syntax
show enclosures
Parameters
Encl
The enclosure ID.
Encl WWN
The enclosure WWN.
Name
The enclosure name.
Location
The enclosure location, or blank if not set.
Rack
The number of the rack that contains the enclosure.
Pos
The position of the enclosure in the rack
Vendor
The enclosure vendor.
Model
The enclosure model.
EMP controller-ID BUS:ID Rev
The channel ID and firmware revision of the Enclosure Management Processor in each controller’s Expander
Controller.
Midplane Type
An abbreviation that describes the enclosure midplane's rack-unit height, maximum number of disks,
maximum data rate to disks (Gbit/s), and hardware version.
Health
• Show information about all enclosures in the system.
# show enclosures
OK
• Degraded
• Fault
• N/A
• Unknown
Reason
If Health is not OK, this field shows the reason for the health state.
Action
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Drawer Information
Drawer
Alphabetical list of commands
191