CLI Guide

• drawer1-ingress: Drawer 1 drawer ingress PHY

• drawer2-ingress: Drawer 2 ingress PHY

• drawer0-ingress-0: Drawer 0 ingress PHY 0

• drawer0-ingress-1: Drawer 0 ingress PHY 1

• drawer0-ingress-2: Drawer 0 ingress PHY 2

• drawer0-egress-0: Drawer 0 egress PHY 0

• drawer0-egress-1: Drawer 0 egress PHY 1

• drawer0-egress-2: Drawer 0 egress PHY 2

• drawer1-ingress-0: Drawer 1 ingress PHY 0

• drawer1-ingress-1: Drawer 1 ingress PHY 1

• drawer1-ingress-2: Drawer 1 ingress PHY 2

• drawer1-egress-0: Drawer 1 egress PHY 0

• drawer1-egress-1: Drawer 1 egress PHY 1

• drawer1-egress-2: Drawer 1 egress PHY 2

• drawer2-ingress-0: Drawer 2 ingress PHY 0

• drawer2-ingress-1: Drawer 2 ingress PHY 1

• drawer2-ingress-2: Drawer 2 ingress PHY 2

• drawer2-egress-0: Drawer 2 egress PHY 0

• drawer2-egress-1: Drawer 2 egress PHY 1

• drawer2-egress-2: Drawer 2 egress PHY 2

[wwn enclosure-WWN]

Optional. The WWN of the enclosure containing the PHY. Specify either this parameter or the encl

parameter.

Examples

Disable the first egress PHY in controller A in enclosure 1.

# set expander-phy encl 1 controller a type egress phy 0 disabled

Enable the PHY for disk 5 in controller B in enclosure 1.

# set expander-phy encl 1 controller b type drive phy 5 enabled

For a 5U84 enclosure’s left-hand drawer, disable egress PHY 0.

# set expander-phy encl 1 controller a type drawer0-egress-0 phy 0 disabled