CLI Guide

set debug-log-parameters
Description Sets the types of debug messages to include in the Storage Controller debug log.
NOTE: This command is for use by or with direction from technical support.
Minimum role manage
Syntax
set debug-log-parameters
message-type+|- [...]
Parameters
message-type+|-
One of the following message types, followed by a plus (+) to enable or a minus (-) to disable inclusion in the
log:
• autotest: Auto-test debug messages. Disabled by default.
• awt: Auto-write-through cache triggers debug messages. Disabled by default.
• bkcfg: Internal configuration debug messages. Enabled by default.
• cache: Cache debug messages. Enabled by default.
• cache2: Extra cache debugging messages that may occur frequently enough to fill logs. Disabled by
default.
• capi: Internal Configuration API debug messages. Enabled by default.
• capi2: Internal Configuration API verbose debug messages. Disabled by default.
• cs: Copy Services feature debug messages. Enabled by default.
• disk: Disk interface debug messages. Enabled by default.
• dms: Not used.
• emp: Enclosure Management Processor debug messages. Enabled by default.
• fo: Failover and recovery debug messages. Enabled by default.
• fruid: FRU ID debug messages. Enabled by default.
• hb: Inter-controller heartbeat debug messages. Disabled by default.
• host: Host interface debug messages. Enabled by default.
• host2: Host/SCSI debug messages. Disabled by default.
• init: Host-port initiator mode debug messages. Disabled by default.
• ioa: I/O interface driver debug messages (standard). Enabled by default
• iob: I/O interface driver debug messages (resource counts). Disabled by default.
• ioc: I/O interface driver debug messages (upper layer, verbose). Disabled by default.
• iod: I/O interface driver debug messages (lower layer, verbose). Disabled by default.
• mem: Internal memory debug messages. Disabled by default.
• misc: Internal debug messages. Enabled by default.
• msg: Inter-controller message debug messages. Enabled by default.
• mui: Internal service interface debug messages. Enabled by default.
• ps: Paged storage debug messages. Enabled by default.
• raid: RAID debug messages. Enabled by default.
• res2: Internal debug messages. Disabled by default.
• resmgr: Reservation Manager debug messages. Disabled by default.
• rtm: Remote Target Manager debug messages. Disabled by default.
Examples
Include RAID and cache messages, exclude EMP messages, and leave other message types unchanged.#
set debug-log-parameters raid+ cache+ emp-
See also
show debug-log-parameters
114 Alphabetical list of commands