CLI Guide
set controller-dat
timestamp timestamp
timezone +|-hh[:mm]
To configure use of NTP:
set controller-date
ntp enabled|disabled|on|off
ntpaddress address
timezone +|-hh[:mm]
Parameters
jan|feb|mar|apr|may|jun|jul|aug|sep|oct|nov|dec
The month.
day
The day number (1–31).
hh:mm:ss
The hour (0–23), the minutes (0–59), and the seconds (0–59).
year
The year as a four-digit number.
ntp enabled|disabled|on|off
Enables or disables use of NTP. When NTP is enabled and the specified NTP server is available, each
controller’s time is synchronized with the server. This is disabled by default.
ntpaddress address
The network address of an available NTP server. The value can be an IPv4 address, IPv6 address, or FQDN.
timezone +|-hh[:mm]
The system’s time zone as an offset in hours (-12 through +14) and optionally minutes (00–59) from
Coordinated Universal Time (UTC). To specify a positive offset, the '+' is optional. To specify a negative
offset, the '-' is required. The hour value can have one or two digits and can omit a leading zero. If the
minutes value is specified it must have two digits. If it is omitted, the minutes value is set to 00.
timestamp timestamp
The date and time represented as the number of seconds (not counting leap seconds) that have elapsed
since 1970-01-01 00:00:00 UTC. The resulting time will be in UTC, unless you also specify the timezone
parameter.
Examples
Manually set the system time and date to 1:45 PM on September 22, 2011.
# set controller-date sep 22 13:45:0 2011
Manually set the system date and time to 4:30:50 PM on November 2, 2011 by specifying a timestamp and an
offset for the Central Time zone.
# set controller-date timestamp 1320273050 timezone -6
Set the system to use NTP with an offset for the Mountain Time zone.
# set controller-date ntp enabled ntpaddress 69.10.36.3 timezone -7
Set the system to use NTP with an offset for the Bangalore, India, time zone.
# set controller-date ntp enabled ntpaddress 69.10.36.3 timezone +5:30
See also
set ntp-parameters
show controller-date
show ntp-status
Alphabetical list of commands 113