CLI Guide

See also show cli-parameters
set cloudiq
Description Enables or disables the ability to use the Dell EMC CloudIQ application on a remote device to monitor, analyze,
and troubleshoot the storage environment.
Storage-system configuration data is sent hourly and performance data is sent every 15 minutes.
CloudIQ cannot be used until the SupportAssist agreement is accepted and SupportAssist is enabled. When
the agreement is accepted and SupportAssist is first enabled, CloudIQ is automatically enabled. Thereafter,
SupportAssist and CloudIQ can be disabled or enabled independently.
Minimum role standard
Syntax
set cloudiq
[enabled|disabled|on|off]
Parameters
enabled|disabled|on|off
At least one parameter must be specified.
• enabled or on: Enables use of the CloudIQ application.
• disabled or off: Disables use of the CloudIQ application. This is the default.
Examples Disable use of CloudIQ.
# set cloudiq disabled
See also
show cloudiq on page 168
set support-assist on page 147
set controller-date
Description
Sets the date and time parameters for the system. You can set the date and time manually or configure the
system to communicate with a Network Time Protocol (NTP) server. Alternatively, you can configure NTP by
using the set ntp-parameters command.
NOTE:
• If you specify valid NTP parameters and manual date/time parameters in the same
command, the NTP parameters will take precedence. If the NTP server cannot be
contacted, the date and time will not be changed and no error message will be displayed. If
you specify the timestamp parameter and other manual date/time parameters in the same
command, the timestamp parameter will take precedence.
• If you change the time zone of the secondary system in a replication set whose primary and
secondary systems are in different time zones, you must restart the system to enable
management interfaces to show proper time values for replication operations.
Minimum role manage
Syntax
To set the date and time manually:
set controller-date
jan|feb|mar|apr|may|jun|jul|aug|sep|oct|nov|dec
day
hh:mm:ss
year
To set the date and time manually by specifying a timestamp:
112 Alphabetical list of commands