Owners Manual
Table Of Contents
- Dell EMC PowerVault ME4 Series Storage System Owner’s Manual
- Contents
- Storage system hardware
- Troubleshooting and problem solving
- Module removal and replacement
- ESD precautions
- Dealing with hardware faults
- Firmware updates
- Continuous operation during replacement
- Shutting down attached hosts
- Shutting down a controller module
- Verifying component failure
- Customer-replaceable units (CRUs)
- Attach or remove the front bezel of a 2U enclosure
- Replacing a drive carrier module in a 2U enclosure
- Replacing a DDIC in a 5U enclosure
- Replacing a controller module or IOM in a 2U or 5U enclosure
- Replacing a power supply unit (PSU) in a 5U enclosure
- Replacing a fan cooling module (FCM) in a 5U enclosure
- Replacing a power cooling module (PCM) in a 2U enclosure
- Completing the component installation process
- Verifying component operation
- Performing updates in PowerVault Manager after replacing an FC or SAS HBA
- Events and event messages
- Connecting to the CLI port using a serial cable
- Technical specifications
- Standards and regulations
Table 27. Event descriptions and recommended actions (continued)
Number Severity Description/Recommended actions
CAUTION: The sideplanes on the enclosure drawers are not hot swappable or
customer serviceable.
Resolved A previous Warning or Error condition for the sideplane element has been resolved.
Recommended actions:
● No action is required.
611 Error Email notification failed due to either:
● An unreachable SMTP server or a difference between the sender and SMTP server domains.
● Improper configuration.
Recommended actions:
● Verify the configured parameters and ask the recipients to confirm that they received the
message.
Info. Email notification sent successfully. Please ask the recipients to confirm that they received the
message.
Recommended actions:
● Verify the configured parameters and ask the recipients to confirm that they received the
message.
612 Info. An alert condition was detected on an internal chassis SAS connector.
The event message specifies the location of the internal SAS connector in the chassis.
Recommended actions:
● No action is required.
613 Error An alert condition was detected on an IOM.
Recommended actions:
● Either install the indicated IOM or attempt to reseat it.
● If the problem persists, replace the IOM.
Warning An alert condition was detected on an IOM.
Recommended actions:
● If uninstalled, install the indicated IOM otherwise attempt to reseat it.
● If the problem persists, replace the IOM.
Info. An IOM was uninstalled.
Recommended actions:
● No action is required.
Resolved A previous Warning or Error condition for the IOM has been resolved.
Recommended actions:
● No action is required.
615 Info. A rebalance operation for an ADAPT disk group has started.
Recommended actions:
● No action is required.
616 Warning A rebalance operation for an ADAPT disk group has completed partially.
Recommended actions:
● No action is required.
Info. A rebalance operation for an ADAPT disk group has completed.
Recommended actions:
144 Events and event messages