CLI Guide

Shown by the detail parameter. The disk LED status:
● Rebuild: The disk's disk group is being reconstructed.
● Fault: The disk has a fault.
● ID: The disk's identification LED is illuminated.
● Remove: The disk is ready to be removed from the enclosure.
● Blank if the disk is not part of a disk group or is spun down.
Location
Shown by default and by any parameter except encl. The disk location in the format enclosure-
ID.slot-number.
Lock Key ID
Shown by the fde parameter. The current lock key ID.
Model
Shown by the encl parameter. The model number of the disk.
Pool
Shown by default. The name of the pool that contains the disk.
Pool Name
Shown by the detail parameter. See Pool, above.
Power On Hours
Shown by the detail parameter. The total number of hours that the disk has been powered
on since it was manufactured. This value is stored in disk metadata and is updated in 30-minute
increments.
Recon State
Shown by the detail parameter. The state of the disk (source or destination) if it is involved in a
reconstruct operation.
● From: This disk is being used as the source of a reconstruct operation.
● To: This disk is being used as the target of a reconstruct operation.
● N/A: This disk is not being used in a reconstruct operation.
Rev
Shown by default or by the detail, fde, or perf parameter. The firmware revision number.
Revision
Shown by the detail parameter. See Rev, above.
Sec Fmt
Shown by default or by the detail or perf parameter. The disk sector format.
● 512n: The disk uses 512-byte native sector size. Each logical block and physical block is 512
bytes.
● 512e: The disk uses 512-byte emulated sector size. Each logical block is 512 bytes and each
physical block is 4096 bytes. Eight logical blocks will be stored sequentially in each physical block.
Logical blocks may or may not be aligned with physical block boundaries.
Serial Number
Shown by default and by any parameter except temp. The serial number of the disk.
Single Pathed
Shown by the detail parameter:
● A or B: A dual-ported disk is communicating through a single port to the connected controller. A
failure is preventing communication through the second port to the other controller.
● (blank): The disk is operating normally.
NOTE: ME4 Series systems support only dual-ported disks.
Size
Alphabetical list of commands
187