CLI Guide

Optional. Specifies whether to change controller A, B, or both. If this parameter is omitted, changes affect
the controller being accessed.
Examples Clear DNS settings for controller A.
# clear dns-parameters controller a
See also
set dns-parameters
set email-parameters
show dns-parameters
show email-parameters
clear events
Description Clears the event log in controller A, B, or both.
Minimum role manage
Syntax
clear events
[a|b|both]
Parameters
[a|b|both]
Optional. The controller event log to clear. If this parameter is omitted, both event logs are cleared.
Examples Clear the event log for controller A.
# clear events a
See also show events
clear expander-status
Description
Clears the counters and status for SAS expander lanes.
NOTE: This command is for use by or with direction from technical support.
Counters and status can be reset to a good state for all enclosures, or for a specific enclosure whose status
is Error as shown by the show expander-status command.
NOTE: If a rescan is in progress, the clear operation will fail with an error message saying that
an EMP does exist. Wait for the rescan to complete and then retry the clear operation.
Minimum role manage
Syntax
clear expander-status
[enclosure ID]
Parameters [enclosure ID]
Optional. The enclosure number. If this parameter is omitted, the command clears the counters and status of
all enclosures.
Examples Clear the expander status for the enclosure with ID 1.
# clear expander-status enclosure 1
See also show expander-status
40 Alphabetical list of commands