CLI Guide

Table 102. sas-status-controller-a properties (continued)
Name Type Description
• Enabled - Degraded : The PHY is enabled but degraded.
• Disabled : The PHY has been disabled by a user or by the system.
status-numeric uint32 Numeric equivalents for status values.
• 0: Unavailable
• 1: Enabled - Healthy
• 2: Enabled - Degraded
• 3: Disabled
elem-status string The SES status that corresponds to the PHY status.
• Disabled : Critical condition is detected.
• Error : Unrecoverable condition is detected. Appears only if there is a firmware
problem related to PHY definition data.
• OK : Element is installed and no error conditions are known.
• Non-critical : Non-critical condition is detected.
• Not Used : Element is not installed in enclosure.
• Unknown : Either:
○ Sensor has failed or element status is not available. Appears only if an I/O
module indicates it has fewer PHYs than the reporting I/O module, in which
case all additional PHYs are reported as unknown.
○ Element is installed with no known errors, but the element has not been turned
on or set into operation.
○ SES status cannot be determined for another reason.
elem-status-numeric uint32 Numeric equivalents for elem-status values.
• 0: Error
• 1: OK
• 2: Disabled
• 3: Non-critical
• 4: Error
• 5: Not Used
• 6: Unknown
• 7: Unknown
•
8: Unknown
elem-disabled string
• Enabled : PHY is enabled.
• Disabled : PHY is disabled.
elem-disabled-numeric uint32 Numeric equivalents for elem-disabled values.
• 0: Enabled
• 1: Disabled
elem-reason string More information about the status value.
• Blank if elem-status is OK.
• Error count interrupts : PHY disabled because of error-count interrupts.
• PHY control : PHY disabled by a SES control page as a result of action by a
Storage Controller or user.
• Not ready : PHY is enabled but not ready. Appears for SC-1 PHYs when the
partner I/O module is not installed. Appears for Drive, SC-1, or Ingress PHYs when a
connection problem exists such as a broken connector.
• Disk removed : PHY disabled because drive slot is empty.
386 API basetype properties