CLI Guide

debug-log-parameters
This basetype is used by show debug-log-parameters on page 173.
Table 28. debug-log-parameters properties
Name Type Description
host-dbg string Shows whether host interface debug messages are enabled for inclusion in the Storage
Controller debug log.
• Off: Disabled.
• On: Enabled.
host-dbg-numeric uint32 Numeric equivalents for host values.
• 0: Off
• 1: On
disk string Shows whether disk interface debug messages are enabled for inclusion in the Storage
Controller debug log.
• Off: Disabled.
• On: Enabled.
disk-numeric uint32 Numeric equivalents for disk values.
• 0: Off
• 1: On
mem string Shows whether internal memory debug messages are enabled for inclusion in the
Storage Controller debug log.
• Off: Disabled.
• On: Enabled.
mem-numeric uint32 Numeric equivalents for mem values.
• 0: Off
• 1: On
fo string Shows whether failover and recovery debug messages are enabled for inclusion in the
Storage Controller debug log.
• Off: Disabled.
• On: Enabled.
fo-numeric uint32 Numeric equivalents for fo values.
• 0: Off
• 1: On
msg string Shows whether inter-controller message debug messages are enabled for inclusion in
the Storage Controller debug log.
• Off: Disabled.
• On: Enabled.
msg-numeric uint32 Numeric equivalents for msg values.
• 0: Off
• 1: On
ioa string Shows whether standard debug messages for an I/O interface driver are enabled for
inclusion in the Storage Controller debug log.
• Off: Disabled.
• On: Enabled.
306 API basetype properties