CLI Guide

See also
show system
show tasks
Description Shows information about tasks.
Minimum role monitor
Syntax
show tasks
[detail] [task-name]
detail
Optional. Shows additional detail about each task.
task-name
Optional. Shows information about the specified task only. If this parameter is omitted, information is shown
for all tasks.
Output
Any task type, no detail
Name
The name of the task.
Type
The task type.
Status
The task status. Status values for each task type are listed in the following sections.
State
The current step of the task. State values for each task type are listed in the following sections.
Error Message
• If an error occurred while processing the task, the error message.
• Blank if no error has occurred.
TakeSnapshot task, detail
Task Name
The name of the task.
Task Type
TakeSnapshot
Status
• Uninitialized: The task is not yet ready to run.
• Ready: The task is ready to run.
• Active: The task is running.
• Error: The task has an error.
• Complete: For a TakeSnapshot task only, the task is complete but not yet ready to run again.
• Deleted: The task is expired but this state is not yet synchronized to the partner controller.
Task State
The current step of the task:
• Start
• VerifyVolume
• CreateName
• CreateSnap
244
Alphabetical list of commands