CLI Guide

Shown by the encl parameter. The model number of the disk.
Pool
Shown by default. The name of the pool that contains the disk.
Pool Name
Shown by the detail parameter. See Pool, above.
Power On Hours
Shown by the detail parameter. The total number of hours that the disk has been powered on since it was
manufactured. This value is stored in disk metadata and is updated in 30-minute increments.
Recon State
Shown by the detail parameter. The state of the disk (source or destination) if it is involved in a reconstruct
operation.
• From: This disk is being used as the source of a reconstruct operation.
• To: This disk is being used as the target of a reconstruct operation.
• N/A: This disk is not being used in a reconstruct operation.
Rev
Shown by default or by the detail, fde, or perf parameter. The firmware revision number.
Revision
Shown by the detail parameter. See Rev, above.
Sec Fmt
Shown by default or by the detail or perf parameter. The disk sector format.
• 512n: The disk uses 512-byte native sector size. Each logical block and physical block is 512 bytes.
• 512e: The disk uses 512-byte emulated sector size. Each logical block is 512 bytes and each physical
block is 4096 bytes. Eight logical blocks will be stored sequentially in each physical block. Logical blocks
may or may not be aligned with physical block boundaries.
Serial Number
Shown by default and by any parameter except temp. The serial number of the disk.
Single Pathed
Shown by the detail parameter:
• A or B: A dual-ported disk is communicating through a single port to the connected controller. A failure is
preventing communication through the second port to the other controller.
• (blank): The disk is operating normally.
Size
Shown by default and by any parameter except fde or temp. The disk capacity, formatted to use the
current base, precision, and units.
Slot
Shown by the encl parameter. The slot number in the enclosure where the disk is located.
SMART
Shown by the detail parameter. Shows whether SMART (Self-Monitoring Analysis and Reporting
Technology) is enabled or disabled for disks.
• Detect-Only: Each disk in the system retains its individual SMART setting, as will new disks added to
the system.
• Enabled: SMART is enabled for all disks in the system and will be enabled for new disks added to the
system.
• Disabled: SMART is disabled for all disks in the system and will be disabled for new disks added to the
system.
Speed (kr/min)
182
Alphabetical list of commands