CLI Guide

[host IP-or-name]
[password proxy-password]
[port port]
{protocol HTTP]
[user proxy-user]
[enabled|disabled|on|off]
Parameters At minimum the host and port parameters must be specified when you enable this feature the first time.
[host IP-or-name]
Optional. Specifies the IPv4 address or name of a proxy host.
[port port]
Optional. Specifies the port number to use on the proxy host.
protocol HTTP
Optional. Specifies the communication protocol. Only HTTP is supported.
[user proxy-user]
Optional. Specifies the proxy user name to use to access the proxy server.
[password proxy-password]
Optional. Specifies the proxy password to use to access the proxy host.
enabled|disabled|on|off
• enabled or on – Enables the feature.
• disabled or off – Disables the feature.
Examples Enable the SupportAssist Proxy feature.
# set support-assist-proxy enable host 10.2.2.2 port 1234
See also
check support-assist
clear support-assist-proxy
send support-assist-logs
set support-assist
set support-assist-info
show support-assist
set syslog-parameters
Description
Sets remote syslog notification parameters for events and managed logs. This allows events to be logged by
the syslog of a specified host computer. Syslog is a protocol for sending event messages across an IP
network to a logging server. This feature supports User Datagram Protocol (UDP) but not Transmission
Control Protocol (TCP).
Minimum role manage
Syntax
set syslog-parameters
[host address]
[host-ip address]
[host-port port-number]
notification-level crit|error|warn|resolved|info|none
Parameters
[host address]
150 Alphabetical list of commands