CLI Guide

[slp enabled|disabled|on|off]
[smis enabled|disabled|on|off]
[snmp enabled|disabled|on|off]
[ssh enabled|disabled|on|off]
[ssh-port port]
[telnet enabled|disabled|on|off]
[usmis enabled|disabled|on|off]
Parameters
[activity enabled|disabled|on|off]
Optional. Enables or disables access to the activity progress interface via HTTP port 8081. This mechanism
reports whether a firmware update or partner firmware update operation is active and shows the progress
through each step of the operation. In addition, when the update operation completes, status is presented
indicating either the successful completion, or an error indication if the operation failed. This is disabled by
default.
[debug enabled|disabled|on|off]
Optional. Enables or disables debug capabilities, including Telnet debug ports and privileged diagnostic user
IDs. This is disabled by default.
NOTE: Properly shut down the debug console by using the set protocols debug disable
command. Do not just close the console directly or by using the exit command.
[ftp enabled|disabled|on|off]
Optional. Enables or disables File Transfer Protocol (FTP), a secondary interface for installing firmware
updates, installing security certificates and keys and downloading logs. This is disabled by default.
[http enabled|disabled|on|off]
Optional. Enables or disables the standard PowerVault Manager web server. This is disabled by default.
[https enabled|disabled|on|off]
Optional. Enables or disables the secure PowerVault Manager web server. This is enabled by default.
[management-mode v2|v3|linear|virtual]
Optional. Sets the default management mode for the system.
• v2 or linear: Uses linear-storage terminology in command output and system messages. For example,
vdisk for disk groups and pools.
• v3 or virtual: Uses terminology in command output and system messages that is generalized for
managing virtual and linear storage. For example, disk group for disk groups and pool for pools. This is the
default.
To change the management mode for the current CLI session only, use the set cli-parameters on
page 110 command.
[ses enabled|disabled|on|off]
Optional. Enables or disables the in-band SCSI Enclosure Services (SES) management interface. This is
disabled by default.
[sftp enabled|disabled|on|off]
Optional. Enables or disables SSH File Transfer Protocol (SFTP), a secure secondary interface for installing
firmware updates, installing security certificates and keys and downloading logs. All data sent between the
client and server will be encrypted. This is enabled by default.
To set the port numbers to use for SFTP and SSH, set the sftp-port and ssh-port parameters, respectively.
The port numbers must differ
[sftp-port port]
Optional. Specifies the port number to use for SFTP. The default is 1022.
[slp enabled|disabled|on|off]
140
Alphabetical list of commands