CLI Guide

between the two controllers. For more information, see help for commands that show
statistics.
Minimum role manage
Syntax
restart sc
[a|b|both]
[noprompt]
Parameters
[a|b|both]
Optional. The controller module containing the controller to restart. If this parameter is omitted, the command
affects the controller being accessed.
[noprompt]
Optional. Suppresses confirmation prompts. Specifying this parameter allows the command to proceed
without user interaction
.
Output Messages are displayed when the controller shut down, when failover is initiated, and when the controller has
restarted.
Examples From controller A, restart the Storage Controller in controller B.
# restart sc b
Restart both Storage Controllers.
# restart sc both
See also
restart mc
shutdown
restore defaults
Description
Restores the default configuration on the controllers.
CAUTION: This command is for use only with the direction from a service technician.
For details about which settings are restored, see Settings changed by restore defaults on page 434.
NOTE: This command restores the default settings to the controllers and restarts each
controller module. Changes to host interface settings may cause loss of data availability and
require some reconfiguration to restore host access to volumes. Changes to network-port IP
addresses may cause loss of access to management interfaces.
Minimum role manage
Syntax
restore defaults
[noprompt]
[prompt yes|no]
Parameters
[noprompt]
Optional. Suppresses confirmation prompts. Specifying this parameter enables the command to proceed
without user interaction.
[prompt yes|no]
• yes: Allow the command to proceed.
• no: Cancel the command.
If this parameter is omitted, you must manually reply to prompts.
Examples Restore the default configuration on the controllers.
100 Alphabetical list of commands