Support Matrix
Table Of Contents
- Dell EMC PowerVault ME4 Series Storage System Support Matrix
- Contents
- Introduction
- Supported data protocols
- ME4 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI SFP+ transceivers
- Supported SAS and Twinax direct-attach cables
- Supported hard drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- Dell EMC Storage Support Policy
Supported Fibre Channel and iSCSI direct-
attach configuration operating systems
ME4 Series storage systems support Fibre Channel and iSCSI direct-attached configurations on the following operating
systems:
● Microsoft Windows Server 2019
● Microsoft Windows Server 2016
● Microsoft Windows Server 2012 R2
● Citrix XenServer 7.1 CU2 or later
● Red Hat Enterprise Linux 8.0 or later
● Red Hat Enterprise Linux 7.4 or later
● Red Hat Enterprise Linux 6.9 or later
● SUSE Linux Enterprise Server 15.0 or later
● SUSE Linux Enterprise Server 12.3 or later
● VMware vSphere 7.0 or later
● VMware vSphere 6.7 or later
● VMware vSphere 6.5 or later
NOTE:
Hyper-V supports direct-attach configurations if Hyper-V is installed as an application on Windows Server 2019.
Hyper-V Server 2019 does not support direct-attach configurations.
19
Supported Fibre Channel and iSCSI direct-attach configuration operating systems 31